Four images of different

sectors of the section selected at random while out of focus were then focused, captured and analysed from each sample. From each image, 10 different regions were randomly selected. However, if the region was in the centre of the fibre, on an area of fibrosis, on a neuromuscular junction or if more than one measurement per fibre was selected, the region was moved slightly to the nearest fibre membrane. The measured regions included both a portion of the cytoplasm and the sarcolemma (Figure 1A). The principles of this technique are the following: when excited, fluorescent labelled antibodies bound to the proteins release photons Tanespimycin ic50 that are captured by the charge-coupled device, and converted into electrons. The number of electrons, which is directly proportional to the intensity of the fluorescence, is then mapped on to an image in MetaMorph and presented as an intensity value (Figure 1B,C). The dynamic range of the camera a 12-bit Photometrics CoolSnapHQ2 [Leica Microsystems (UK) Ltd, Milton Keynes, UK] was 0–4095 intensity units and our measurements were taken so that pixel saturation was avoided (all our intensity measurements were well

below the saturation limit). Intensity measurements of these regions were logged into a spreadsheet Dorsomorphin for data analysis. For each antibody used, 40 different measurements from each sample were taken. Each region where intensity values were measured contained a portion of the cytoplasm and of the sarcolemma, reflecting the location of the proteins of interest. For each region, the minimum intensity value recorded (representative of the cytoplasm or background intensity) was subtracted from the maximum intensity value (which corresponded to the sarcolemma) to correct each measurement for Resveratrol background intensity. To correct for variation of sarcolemmal integrity between samples,

we performed the same measurements on serial sections stained with a β-spectrin antibody. The spectrin intensity values obtained for the control samples were set as the standard to calculate normalization factors. For each of the antibodies, the minimum intensity value was subtracted from the maximum, then these values (one per each of the 40 fibres analysed) were normalized with the β-spectrin measurements and plotted on a graph. Data are presented in scatter plots and summarized as a ratio of the control. Statistical analysis of the data was performed using one-way analysis of the variance. We compared muscle sections taken from a normal control, a DMD patient, a BMD patient and a manifesting carrier, using two dystrophin antibodies (Dys2 and P7). We also studied in parallel the intensity of dystrophin-associated complex proteins (ASG, BDG) and UTR (Figure 2A).